HP HPE FlexNetwork 7500 series User Manual

416
Displaying and maintaining RIPng
Execute display commands in any view and reset commands in user view.
Task
Command
Display configuration information for a
RIPng process.
display ripng
[ process-id ]
Display routes in the RIPng database.
display ripng
process-id
database
[ ipv6-address
prefix-length ]
Display RIPng GR information.
display ripng
[ process-id ]
graceful-restart
Display interface information for a RIPng
process.
display ripng
process-id
interface
[ interface-type
interface-number ]
Display neighbor information for a RIPng
process.
display ripng
process-id
neighbor
[ interface-type
interface-number ]
Display RIPng NSR information.
display ripng
[ process-id ]
non-stop-routing
Display the routing information for a RIPng
process.
display ripng
process-id
route
[ ipv6-address prefix-length
[
verbose
] |
peer
ipv6-address |
statistics
]
Restart a RIPng process.
reset ripng
process-id
process
Clear statistics for a RIPng process.
reset ripng
process-id
statistics
RIPng configuration examples
Basic RIPng configuration example
Network requirements
As shown in Figure 95, Switch A, Switch B, and Switch C run RIPng. Configure Switch B to filter the
route 2::/64 learned from Switch A and to forward only the route 4::/64 to Switch A.
Figure 95 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure basic RIPng:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ripng 1
[SwitchA-ripng-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] ripng 1 enable
Vlan-int100
1::2/64
Vlan-int200
3::2/64
Vlan-int500
5::1/64
Vlan-int200
3::1/64
Vlan-int600
4::1/64
Vlan-int400
2::1/64
Vlan-int100
1
::
1/64
Switch A
Switch B
Switch C

HP HPE FlexNetwork 7500 series Specifications

General

Brand	HP
Model	HPE FlexNetwork 7500 series
Category	Switch
Language	English