34
3. Set RIP timers.
timers
{
garbage-collect
garbage-collect-value |
suppress
suppress-value |
timeout
timeout-value |
update
update-value } *
By default:
• The garbage-collect timer is 120
seconds.
• The suppress timer is 120
seconds.
• The timeout timer is 180 seconds.
• The update timer is 30 seconds.
Enabling split horizon and poison reverse
The split horizon and poison reverse functions can prevent routing loops.
If both split horizon and poison reverse are configured, only the poison reverse function takes effect.
Enabling split horizon
Split horizon disables RIP from sending routes through the interface where the routes were learned
to prevent routing loops between adjacent routers.
To enable split horizon:
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Enable split horizon.
rip split-horizon
By default, split horizon is
enabled.
Enabling poison reverse
Poison reverse allows RIP to send routes through the interface where the routes were learned. The
metric of these routes is always set to 16 (unreachable) to avoid routing loops between neighbors.
To enable poison reverse:
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Enable poison reverse.
rip poison-reverse
By default, poison reverse is
disabled.
Setting the maximum number of RIP ECMP routes
Perform this task to implement load sharing over ECMP routes.
To set the maximum number of RIP ECMP routes:
1. Enter system view.
system-view
N/A
To Next Page
Loading...
Need help?
General