HP HPE FlexNetwork 7500 series User Manual

483
Step
Command
Remarks
5. Enable IPv6 IS-IS MTR.
multi-topology
[
compatible
]
By default, IPv6 IS-IS MTR is
disabled.
Displaying and maintaining IPv6 IS-IS
Execute display commands in any view. For other display and reset commands, see "Configuring
IS-IS."
Task
Command
Display information about routes
redistributed by IPv6 IS-IS.
display isis redistribute ipv6
[ ipv6-address mask-length ]
[
level-1
|
level-2
] [ process-id ]
Display IPv6 IS-IS routing information.
display isis route ipv6
[ ipv6-address ] [ [
level-1
|
level-2
] |
verbose
] * [ process-id ]
Display IPv6 IS-IS topology information.
display isis spf-tree ipv6
[ [
level-1
|
level-2
] |
verbose
] *
[ process-id ]
Display IPv6 IS-IS route calculation log
information.
display isis event-log spf ipv6
[ [
level-1
|
level-2
] |
verbose
] * [ process-id ]
IPv6 IS-IS configuration examples
IPv6 IS-IS basic configuration example
Network requirements
As shown in Figure 112, Switch A, Switch B, Switch C, and Switch D, all enabled with IPv6, reside in
the same AS. Configure IPv6 IS-IS on the switches so that they can reach each other.
Switch A and Switch B are Level-1 switches, Switch D is a Level-2 switch, and Switch C is a
Level-1-2 switch.
Figure 112 Network diagram
Configuration procedure
1. Configure IPv6 addresses for interfaces. (Details not shown.)
2. Configure IPv6 IS-IS:
Vlan-int
300
2001:3::2/64
Vlan-int
301
2001:4
::1/64
Switch D
L2
Area
20
Switch B
L1
Switch C
L1/L2
Vlan
-int100
2001:1::2/64
Vlan-int100
2001:1::1/64
Vlan-
int200
2001:2::1/64
Vlan-int200
2001:2::2/64
Vlan-
int300
2001:3::1/64
Switch A
L1
Area 10

HP HPE FlexNetwork 7500 series Specifications

General

Brand	HP
Model	HPE FlexNetwork 7500 series
Category	Switch
Language	English