HP HPE FlexNetwork 7500 series User Manual

81
To configure Type-3 LSA filtering:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter OSPF view.
ospf
[ process-id |
router-id
router-id
|
vpn-instance
vpn-instance-name ]
*
N/A
3. Enter area view.
area
area-id
N/A
4. Configure Type-3 LSA
filtering.
filter
{ ipv4-acl-number |
prefix-list
prefix-list-name |
route-policy
route-policy-name } {
export
|
import
}
By default, the ABR does not
filter Type-3 LSAs.
Setting an OSPF cost for an interface
Set an OSPF cost for an interface by using either of the following methods:
•
Set the cost value in interface view.
•
Set a bandwidth reference value for the interface. OSPF computes the cost with this formula:
Interface OSPF cost = Bandwidth reference value (100 Mbps) / Expected interface bandwidth
(Mbps). The expected bandwidth of an interface is configured with the bandwidth command
(see Interface Command Reference).
 If the calculated cost is greater than 65535, the value of 65535 is used. If the calculated cost
is less than 1, the value of 1 is used.
 If no cost or bandwidth reference value is configured for an interface, OSPF computes the
interface cost based on the interface bandwidth and default bandwidth reference value.
To set an OSPF cost for an interface:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Set an OSPF cost for
the interface.
ospf cost
cost-value
By default, the OSPF cost is calculated
according to the interface bandwidth.
For a loopback interface, the OSPF cost
is 0 by default.
To set a bandwidth reference value:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter OSPF view.
ospf
[ process-id |
router-id
router-id |
vpn-instance
vpn-instance-name ] *
N/A
3. Set a bandwidth
reference value.
bandwidth-reference
value
The default setting is 100 Mbps.

HP HPE FlexNetwork 7500 series Specifications

General

Brand	HP
Model	HPE FlexNetwork 7500 series
Category	Switch
Language	English