142
(Optional.) Configuring IS-IS route control:
• Configuring IS-IS link cost
• Specifying a preference for IS-IS
• Configuring the maximum number of ECMP routes
• Configuring IS-IS route summarization
• Advertising a default route
• Configuring IS-IS route redistribution
• Configuring IS-IS route filtering
• Configuring IS-IS route leaking
• Advertising IS-IS link state information to BGP
(Optional.) Tuning and optimizing IS-IS networks:
• Specifying the interval for sending IS-IS hello packets
• Specifying the IS-IS hello multiplier
• Specifying the interval for sending IS-IS CSNP packets
• Configuring a DIS priority for an interface
• Disabling an interface from sending/receiving IS-IS packets
• Enabling an interface to send small hello packets
• Configuring LSP parameters
• Controlling SPF calculation interval
• Configuring convergence priorities for specific routes
• Setting the LSDB overload bit
• Configuring the ATT bit
• Configuring the tag value for an interface
• Configuring system ID to host name mappings
• Enabling the logging of neighbor state changes
• Enabling IS-IS ISPF
• Enabling prefix suppression
• Configuring IS-IS network management
• Configuring IS-IS PIC
(Optional.) Enhancing IS-IS network security:
• Configuring neighbor relationship authentication
• Configuring area authentication
• Configuring routing domain authentication
(Optional.) Configuring IS-IS GR
(Optional.) Configuring IS-IS NSR
(Optional.) Configuring BFD for IS-IS
(Optional.) Configuring IS-IS FRR
Configuring basic IS-IS
Configuration prerequisites
Before the configuration, complete the following tasks:
Configure the link layer protocol.
Configure IP addresses for interfaces to ensure IP connectivity between neighboring nodes.
To Next Page
Loading...
Need help?
General