EasyManuals Logo
Home>HP>Switch>HPE FlexNetwork 7500 series

HP HPE FlexNetwork 7500 series User Manual

HP HPE FlexNetwork 7500 series
592 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #295 background imageLoading...
Page #295 background image
283
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP instance view or
BGP-VPN instance view.
• Enter BGP instance view:
bgp as-number [ instance
instance-name ]
• Enter BGP-VPN instance
view:
a. bgp as-number
[ instance
instance-name ]
b. ip vpn-instance
vpn-instance-name
N/A
3. Disable BGP to establish a
session to a peer or peer
group.
peer
{ group-name | ipv4-address
[ mask-length ] }
ignore
By default, BGP can establish a
session to a peer or peer group.
To disable BGP to establish a session to a peer or peer group (IPv6 unicast/multicast address
family):
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP instance view or
BGP-VPN instance view.
• Enter BGP instance view:
bgp as-number [ instance
instance-name ]
• Enter BGP-VPN instance
view:
a. bgp as-number
[ instance
instance-name ]
b. ip vpn-instance
vpn-instance-name
N/A
3. Disable BGP to establish a
session to a peer or peer
group.
peer
{ group-name | ipv6-address
[ prefix-length ] }
ignore
By default, BGP can establish a
session to a peer.
Configuring GTSM for BGP
The Generalized TTL Security Mechanism (GTSM) protects a BGP session by comparing the TTL
value in the IP header of incoming BGP packets against a valid TTL range. If the TTL value is within
the valid TTL range, the packet is accepted. If not, the packet is discarded.
The valid TTL range is from 255 – the configured hop count + 1 to 255.
When GTSM is configured, the BGP packets sent by the device have a TTL of 255.
GTSM provides best protection for directly connected EBGP sessions, but not for multihop EBGP or
IBGP sessions because the TTL of packets might be modified by intermediate devices.
IMPORTANT:
•
When GTSM is configured, the local device can establish an EBGP session to the peer after both
devices pass GTSM check, regardless of whether the maximum number of hops is reached.
•
To use GTSM, you must configure GTSM on both the local and peer devices. You can specify
different hop-count values for them.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP HPE FlexNetwork 7500 series and is the answer not in the manual?

HP HPE FlexNetwork 7500 series Specifications

General IconGeneral
BrandHP
ModelHPE FlexNetwork 7500 series
CategorySwitch
LanguageEnglish

Related product manuals