HP HPE FlexNetwork 7500 series User Manual

410
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter RIPng view.
ripng
[ process-id ]
[
vpn-instance
vpn-instance-name ]
N/A
3. Set a preference for RIPng.
preference
{ preference |
route-policy
route-policy-name }
*
By default, the preference of
RIPng is 100.
Configuring RIPng route redistribution
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter RIPng view.
ripng
[ process-id ]
[
vpn-instance
vpn-instance-name ]
N/A
3. Redistribute routes from
other routing protocols.
import-route
protocol
[ as-number | process-id ]
[
allow-ibgp
] [
allow-direct
|
cost
cost-value |
route-policy
route-policy-name ] *
By default, RIPng does not
redistribute routes from other
routing protocols.
4. (Optional.) Set a default
routing metric for
redistributed routes.
default cost
cost-value
The default metric of redistributed
routes is 0.
Tuning and optimizing the RIPng network
This section describes how to tune and optimize the performance of the RIPng network as well as
applications under special network environments.
Before you tune and optimize the RIPng network, complete the following tasks:
•
Configure IPv6 addresses for interfaces to ensure IPv6 connectivity between neighboring
nodes.
•
Configure basic RIPng.
Setting RIPng timers
You can adjust RIPng timers to optimize the performance of the RIPng network.
When you adjust RIPng timers, consider the network performance, and perform unified
configurations on routers running RIPng to avoid unnecessary network traffic or route oscillation.
To set RIPng timers:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter RIPng view.
ripng
[ process-id ]
[
vpn-instance
vpn-instance-name ]
N/A

HP HPE FlexNetwork 7500 series Specifications

General

Brand	HP
Model	HPE FlexNetwork 7500 series
Category	Switch
Language	English