HP HPE FlexNetwork 7500 series

240
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP IPv4 unicast
address family view,
BGP-VPN IPv4 unicast
address family view, or BGP
IPv4 multicast address family
view.
• Enter BGP IPv4 unicast
address family view:
a. bgp as-number
[ instance
instance-name ]
b. address-family ipv4
[ unicast ]
• Enter BGP-VPN IPv4 unicast
address family view:
c. bgp as-number
[ instance
instance-name ]
d. ip vpn-instance
vpn-instance-name
e. address-family ipv4
[ unicast ]
• Enter BGP IPv4 multicast
address family view:
f. bgp as-number
[ instance
instance-name ]
g. address-family ipv4
multicast
N/A
3. Specify the maximum
number of routes that a
router can receive from a
peer or peer group.
peer
{ group-name | ipv4-address
[ mask-length ] }
route-limit
prefix-number [ {
alert-only
|
discard
|
reconnect
reconnect-time } |
percentage-value ] *
By default, the number of routes
that a router can receive from a
peer or peer group is not limited.
To limit routes that a router can receive from a peer or peer group (IPv6 unicast/multicast address
family):
Step
Command
Remarks
1. Enter system view.
system-view
N/A