287
To save all route updates from the specified peer or peer group (IPv6 unicast/multicast address
family):
1. Enter system view.
system-view
N/A
2. Enter BGP IPv6 unicast
address family view,
BGP-VPN IPv6 unicast
address family view, or BGP
IPv6 multicast address family
view.
• Enter BGP IPv6 unicast
address family view:
a. bgp as-number
[ instance
instance-name ]
b. address-family ipv6
[ unicast ]
• Enter BGP-VPN IPv6 unicast
address family view:
c. bgp as-number
[ instance
instance-name ]
d. ip vpn-instance
vpn-instance-name
e. address-family ipv6
[ unicast ]
• Enter BGP IPv6 multicast
address family view:
f. bgp as-number
[ instance
instance-name ]
g. address-family ipv6
N/A
3. Save all route updates from
the peer or peer group.
peer
{ group-name | ipv6-address
[ prefix-length ] }
keep-all-routes
By default, the routes are not
saved.
This command takes effect only
for the routes received after this
command is executed.
Configuring manual soft-reset
To configure manual soft-reset (IPv4 unicast/multicast address family):
1. Enter system view.
N/A
To Next Page
Loading...
Need help?
General