HP StorageWorks 300 - Virtual Library System EVA Gateway - Output Commands; VLS Commands; Network Settings Configuration Commands; CLI Output Commands

Output comma
nds
Use the CLI commands in to control the output and display help information for the CLI commands.
Table 5 CLI ou
tput com man ds
Command
Description
trace
Displays the stack trace after an exception has occurred.
verbose
Toggles verb
ose output on and off. When on, all messages
are output t
othescreen.
version
Indicates current CLI version. If verbose is on, the mo dule
revisions display also.
help
Displays CLI command usage information. Where <-tag>
can be:
-c<command> -Provideshelpinformationforthespecified
CLI command
-all - Lists all CLI comman ds and their help information
VLS c ommands
This section describes the VLS commands in the VLS CLI command set.
Network settings configuration commands
Use the CLI commands in to configure the VLS network settings via a serial session. See Op ening
aserials
ession.
Changing the network configuration parameters modi fi es four system files:
/etc/hosts
/etc/sysc
onfig/network
/etc/resolv.conf
/etc/sysconfig/network-scrips/ifcfg-eth1
108
CLI command set