HP StorageWorks 300 - Virtual Library System EVA Gateway - Replacing a Primary Node; Aligning the Processor Pins with the Socket Holes; Closing the Processor Locking Lever and Retaining Clips

Figure 84 Aligning the processor pins with t h e socket holes
3. Install the processor and close the processor locking lever (2) and processor retaining clips (1).
1
1
2
3
Figure 85 Clos ing the processor lockin g l ever and retaining clip s
4. Lower the processor retaining card.
5. Install the access panel. See Installing the VLS node access panel.
6. Slidethenodeintotherack.
7. Power on the node. See Powering on the VLS300 system.
Replacing a primary node
CAUTION:
Each VLS300 node w eighs 16.78 kg (37 lb) full. At least two people are required to lift and move
each no
de.
To replace a primary node:
1. Remove the existing node from the rack:
a. Power off the system. See Powering off the system.
b. From the back of the node, make a note of all cable connections then disconnect the cables.
HP StorageWorks
139