5. Push levers on either side of the m iddle fan toward the front of the chassis (1). Rock the fan module
slightlyandpullupandoutofthenode.
1
1
2
Figure78Removingthenodepowersupplyzonefanmodule
CAUTION:
When replacing the component, be sure the power converter module, which is located just in front of the
fan module, is properly seated in the node chassis.
To replace the component, reverse the removal procedure.
Processor zone fan module
CAUTION:
Do not operate the node for long periods without the access panel. Operating the node without the
access panel results in improper airflow and improper cooling that can lead to thermal damage.
1. Extend or remove the node from the rack. See Extending the nod e from the rack.
2. Remove the access panel. See Removing the VLS node access panel.
3. Loosen the single thumbscrew that secures the processor fan mo dule to the node (1) .
4. Push on the sheet metal tab near the thumbscrew to separate the fan tray connector from the system
board connector (2).
5. Slidethecomponentoutthefrontofthenode.
HP StorageWorks
135
To Next Page
Loading...
