HP StorageWorks 300 - Virtual Library System EVA Gateway - Creating Cartridges; Create Virtual Library Wizard Window (7 of 12)

Figure 43 Create Virtu a l Library Wizard window (7 of 12)
9. Choose one of the following options:
• To perform LUN mapping for the virtual tape drive, click Map LUNs and proceed to LUN
mapping for further instructions.
• Tocreatemoretapedrives,clickCreate More Tape Drives.
• To add cartridges to the virtual librar y, click Create Cartridges and proceed to Creating
cartridges.
•Toexitthewizard,clickCancel.
At this point the library and tape drives have been created, but the library does not contain
any cartridges. You can add car tridges later.
Creating cartridges
To add ca
rtridges to a virtual library:
1. If you a
re already in the Create Library Wizard window (Figure 43), click Create Car tridges .
The Cartridge Parameters window opens (Figure 44).
2. If not:
a. Click the System tab.
b. Selec
t the virtual library in the navigation tree to which you are adding cartridges.
c. Click Create Cartridge in the task bar.
The Cartridge Parameters window opens (Figure 44).
HP StorageWorks
77