Creating tape dr
ives
NOTE:
If you add a virtual tape drive to a library after another library has been created, the default LUN
numberassignedtothetapedrivewillnotbeconsecutivewiththeothervirtualtapedrivesinthesame
library. To cor
rect this, restart the VLS device emulations. See Restarting the VLS device emulations.
The VLS softwar
ewillchangethevirtualdeviceLUNnumbersontheVLSsothatallthedefaulttape
drive LUNs in a library are consecutive.
NOTE:
A virtual library may only contain one type of tape drive.
To add a tape drive(s) to a virtual library:
1. If you are already in the Create Library Wizard window , click Create Tape Drive(s).
The Tape Drive Parameters window opens.
2. If not:
a. Click the System tab.
b. Select the library in the navigation tree to which you want to add tape drives.
c. Click Create Tape Drive in the task bar.
The Tape Drive Parameters window opens (Figure 41).
Figure 41 C reate Virtual Library Wizard window (5 of 12)
3. Selectthetypeofphysicaltapedrivetoemulate.
4. Enter the FC host por t and node on which to present the tape drive(s) in the Port Mapping box.
Only one
port or p or t pair may be selected.
5. Click Next Step.
The next Tape Drive Parameters window opens (Figure 42).
HP StorageWorks
75
To Next Page
Loading...
