11194
Figure 5 Switch 2824 rail installation, front
c. At the front of the rack, slide the clip onto the rack so that the hexagonal hole is facing out
and align the holes in the clip with the proper hole in the rack. Then align the rail hole with
these holes.
11195
1
2
Figure 6 Switc h 2824 rail install a tion, ba ck
d. Push the screw through the rail, clip, and rack, then into the nut. Tighten the screw to secure
the rail to the rack (see Figure 6).
e. Repeat these tasks for the rail on the other side of the rack.
Attach ra ils to the 2824 switch
To attach the r ails to the 2824 sw itc h:
1. Align th
e inner rail with the switch so that the perpendicular screw hole faces away from the switch
but is p
arallel to the switch bezel (face-plate) . The two holes at the front of the rail must align with the
two hol
es at the front of the switch (see Figure 7).
HP StorageWorks
29
To Next Page
Loading...
