HP StorageWorks 300 - Virtual Library System EVA Gateway - Processor; Lifting the Processor Retaining Card

Processor
The VLS300nodes each include two pr ocessors. With two processors installed, the node supports boot
functions thr ough the pr ocessor installed in pr ocessor socket 1. However, if processor 1 fails, the system
automatically boots from processor 2 and provides a processor failure message.
Thenodeusesem
bedded PPM s as DC-to-DC converters to provide the proper power to each processor.
CAUTION:
To prevent thermal instability and damage to the node, do not separate the processor from the heatsink.
The processor, heatsink, and retaining clip make up a single assembly.
CAUTION:
To prevent possible node malfunction and damage to the equipment, replace the processors with the
same make and type of processor.
T o remove a processor:
1. Power off the node. See Powering off the system.
2. Extendthenodefromtherack.SeeExtending the node from the rack.
3. Remove the access panel. See Removing the VLS node access panel.
4. Rotate the p rocessor retaining card upward (Figure 81).
Back
Figure 81 Lifting the processor retainin g card
5. Release the processor retaining clips on either side of the processor assembly (1) (Figure 82).
6. Unlock the processor from the connector by lif ting and swinging the locking lever over about 180
degrees (2).
HP StorageWorks
137