NOTE:
Do not format the LUNs when manually creating previously existing pools after
performing a disaster recovery of the primary node. If you do not format the LUN, all
cartridge data in that pool is retained.
f. Click Finish to add the LUNs to the pool.
The pool is now ready to have cartridges created.
NOTE:
If you created storage pools on a LUN that already contained cartridges, update the Allocated Capacity
numbers. To do this, select Cartridges from the system navi gation pane, then select View for the All listing.
Destroying storage pools
Command View VLS allows you to destroy a specific storage pool or all storage pools.
NOTE:
Iftherearecartridgesinthepoolorpoolswhentheyaredestroyed,emulationswillrestart.Toavoidthis
restart, delete all c artridges from the pool prior to deleting the pool. (see Destroying cartridges).
To delete a single storage pool:
1. Open a Command View VLS session and log in as the administrator. See Opening a Command
View VLS session from Command View TL.
2. In the Storage tab nav igation tree, select the pool to delete (listed under Storage Pools).
3. From the task bar, select Destroy Storage Pool.TheConfirm Destroy <storagepool name>
window is displayed (Figure 20).
Figure 20 Confirm Destroy Storage Pool win d ow
4. Select Next to destroy the pool.
44
Storage configuration
To Next Page
Loading...
