HP StorageWorks 300 - Virtual Library System EVA Gateway - Attach Rails to the VLS300 (Appliance); Install Rails; Remove Slides from Rails

5201b
Figure 1 Install rails
c. Repeat these tasks for the rail on the other side of the rack.
3. Remove the inner slide rails from the outer slide rails. To do so, extend the inner slide rails from the
front of the rack until they lock in place. Then press the inner rail release latch (see Figure 2)and
pull the inner slide rails straight out.
10685A
Figure 2 Remove slides from rails
Attach rails to the VLS300 (appliance)
To attach the rails to the appliance:
1. Align the rail with the node so that the word “FRONT” on the rail is seen right-side-up and at the
front of the node.
26
Hardware installation