HP StorageWorks 300 - Virtual Library System EVA Gateway - Setting the Network Settings Using Command View VLS

To set the network settings using the CLI command set:
1. Open a serial session and log in to the administrator account. See Opening a serial session.
2. Toseethecurrentconfiguration settings, at the prompt enter:
showConfig
3. Set each desired configuration value by entering:
setConfigValue <-tag> [value]
where <-tag> canbeanyofthefollowing:
Tag
Description
-host
Host name (such as vlsexamp) (unqualified)
-domain
DNS domain name (such as xyz.com)
-full-
host
Fully qualifie
d name (such as vlsexamp.xyz.com)
-dnsaddr
DNS server address (replaces all addresses with one
line)
-dnsaddr1
First DNS server address (cannot use with dnsaddr)
-dnsaddr2
Second DNS s
erver address (cannot use with dnsaddr)
-dhcp
Has no value, indicates you want to configure the
public Ethernet connection using DHCP (reset is
-dhcp=false)
-ipaddr
IP address of public Ethernet connection
-gate
Gateway to
network (xx.xx.xx.x)
-mask
Netmask. Default is 255.255.255.0
NOTE:
More than o
ne net work value can be set at a time or you can set them individually.
To reset a v
alue, enter “ “ (quoted space) as the value.
4. Verify the network setting(s) has been changed by entering:
showConfig
5. When all the network parameters are set to your desired values, save the settings by entering:
commitConfig
Setting the network settings using Command View VLS
To set the net work settings using Command View VLS, set either the:
• D H CP usage and host name, or
• Fully qualified host name (or host name and DNS domain name separately), DNS server address,
IP address, gateway, and netmask
To set the network settings using Command View VLS:
1. Open a Command View VLS session and log in as the administrator. See Opening a Command
View VLS session from Command View TL.
2. On the System tab, select Chassis in the navigation tree.
3. Select Set Network Configuration under M a intenance Tasks.
64
Configuration