A second page of the Confirm Destroy <storagepool na m e > screen is displayed , containing the
following text: WARNING: Existing data in StoragePool # will be destroyed and cannot be recovered.
This step ca nnot be reversed.
5. Select Finish to display the screen c on firming that the storage p ool has been destroyed.
6. Select Finish a gain to return to the system screen.
You can now either use the LUNs previously assigned to the destroyed pool in other pools, or
they can be d eleted.
To delete all storage pools:
1. Open a Command View VLS session and log in as the administrator. See Opening a Command
View VLS session from Command View TL.
2. In the Storage tab navigation tree , select Storage Pools.
3. If you wish to destroy all storage pools, from the task bar, select Destroy All Storage Pools.The
Confirm Destroy All Storage Pools screen is displayed.
4. Select Next to destroy the pools.
Either recreate storage p o ols using the LUNs previously assigned to the destroyed pool(s), or delete
them.
Installing capacity licenses
A V LS capacity license must be installed on the VLS when storage exceeds the base license. If you are
in a license violation state, a ll VLS read/write operations are disabled until either sufficient licenses
are insta
lled to support the storage, or until excess storage is removed. Unconfigured VLS300 array
LUNs are c
ounted by the system; therefore, they can contribute to license violation. When you have
cleared a license violation by installing an upgrade capacity license, the VLS read/write operations are
automatically enabled without requiring a reboot.
NOTE:
See the
HP
OpenView Command View for TL User Guide
for instructions on performing the following
steps.
TheVLSnetworksettingsmustbesetbeforeacapacitylicensecanbeinstalled.SeeSetting the network
settings.
To install a capacity license on the VLS:
1. Install Command View TL.
2. Start Command View TL.
3. Complete the Command View TL initial configuration steps.
4. Add the VLS to Command View TL.
5. Open a Command View VLS session from Command View TL for the VLS. See Opening a Command
View VLS session from Command View TL.
6. Click the Identity tab.
The Identity tab window opens (Figure 21).
HP StorageWorks
45
To Next Page
Loading...
