The node i s now without p ower.
To power off the system from Command View VLS:
1. Verify that any backup or restore operation has completed and that the VLS is idle.
2. O pen a Command View VLS session and log in as the administrator. See Opening a Command
View VLS session from a web browser.
3. Under the System tab, select C hassis in the navigation tree.
4. Under Maintenance Tasks,selectSystem Maintenance.
5. Select Shutdown All Nodes from the task bar.
Shutdown H ead Wizard displays (Figure 23).
Figure 23 Shutdown Head Wizard win dow
6. Select Yes to shut down all nodes.
7. If you will be removing the access panel from a node, wait until the VLS has completed its shutdown
operation, then press the UID LED button. See Front panel LEDs and buttons.
Blue LEDs illuminate on the front and rear panels of the node.
8. Press the Power On/Standby button on all nodes to place the nodes in standby mode.
When a node activates standby power mode, the system power LED changes to amber.
9. If you will be removing the access panel from a nod e :
a. Go to the back of the rack and locate the node by identifying the illuminated rear UID LED
button.
b. Unplug the node AC power cords from the power source.
The node i s now without p ower.
HP StorageWorks
49
To Next Page
Loading...
