HP StorageWorks 300 - Virtual Library System EVA Gateway - DIMM; Removing the Processor Zone Fan Module; Removing the Node DIMM

1
2
3
Figure 79 Removing the processor zone fan module
T o replace the component, reverse the removal procedure.
DIMM
1. Power off th
enode. SeePowering off the system.
2. Extend or r
emove the node from the rack. See Extending the node from the rack.
3. Remove the access panel. See Removing the VLS node access panel.
4. Open the DIMM slot latches (1).
5. Remove th
eDIMM.
1
1
2
Figure80RemovingthenodeDIMM
CAUTIO
N:
Use onl
y Compaq branded or HP DIMM s. DIMMs from other sources may adversely affect data integrity.
T o replace the component, reverse the removal procedure.
NOTE:
DIMMs do not seat fully if turned the wrong way.
When replacing a DIMM, align the DIMM with the slot and insert the DIMM firmly, pressing down until
the DIMM snaps into place. When fully seated, the DIMM slot latches lock into place.
136
Component replacement