5Operation
This section describes how to power on and power off the VLS nodes. It is comprised of the following
topics:
• Powering on the VLS300 system
• Rebooting the system
• Powering off the system
Powering on t
he VLS300 system
To power on the VLS300 system:
1. Power on all a rrays connected to the VLS300.
2. Power on the
two p rivate LAN switches connected to the VLS300.
3. Plug the VLS300 nodes’ AC power cords into a power source if not already connected.
4. Press the VLS300 secondary nodes’ Power On/Standby button. After the secondary nodes are
powering up, press the primary node’s Power On/Standby button. See Front panel LEDs and buttons.
5. Confirm that the VLS components are all functioning normally and the VLS is cabled correctly by
observing the condition of their status LEDs.
6. Rebooting the system is complete when you receive the “Initializing node#”, then “Initializing for
node# completed.” messages for all nodes in the systems notifications.
Rebooting the system
To reboot the system:
To reboot from VLS CLI:
1. Verify that any backup or restore operation has completed and that the VLS is idle.
2. O pen a secure shell session and log in as the administrator. See Opening a secure shell session.
3. Initiate a reboot of the VLS by entering:
restartSystem
To reboot from Command View VLS:
1. Verify that any backup or restore operation has completed and that the VLS is idle.
2. O pen a Command View VLS session and log in as the administrator. See Opening a Command
View VLS session from a web browser.
3. Under the System tab, select C hassis in the navigation tree.
4. Under Maintenance Tasks,selectSystem Maintenance.
5. Select Restart All Nodes from the task bar.
Restart Head Wizard displays (Figure 22).
HP StorageWorks
47
To Next Page
Loading...
