HP StorageWorks 300 - Virtual Library System EVA Gateway - Power Supply; Ejecting the CD-ROM Drive; Removing a Node Power Supply

NOTE:
The ejector button for the CD -ROM drive is recessed to prevent accidental ejection; it may
be helpful to use a s mall, blunt object, such as a pen, to push the ejector button.
2. Press the ejector button in firmly until the CD-ROM driv e ejects (1).
3. Pull the CD-ROM drive out of the node.
1
2
Figure 74 Eje ctin g the CD-ROM drive
To replace the component:
1. Carefully align the connector on the rear of the drive with the connector on the CD-ROM/diskette
drive interface board.
2. Slide the drive into the bay until it clicks.
Power supply
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are populated
with either a component or a blank.
1. Disconnect the power cord from the power supply.
2. Press the power supply release lever (1), and then pull the power supply from the node.
1
2
Figure 75 Removing a node power supply
To replace the component:
HP StorageWorks
133