HP StorageWorks 300 - Virtual Library System EVA Gateway - Storage Configuration; Establishing Communication between the VLS300 and the EVA; Verifying Array Zoning; Presenting the Luns

4Storageconfigura tion
After all of the nodes have been configured, configure the storage:
• Establishing communication between the VLS300 and the EVA
• Managing VLS300 capacity
• Installing capacity licenses
Establishing
communication between the VLS300 and the EVA
Verifying array zoning
Verify that you have configured the zoning between the EVA ports a nd all storage ports on all the nodes
of your VLS300. For example, storage ports 2 and 3 on each node should connect to different SAN
zones/fabrics; EVA controllers should also be connected to both zones/fabrics. If you have not done
so, refer to the VLS solutions guide to do so now.
Presenting the LUNs
1. G a ther the device WWP N s.
a. From Command View VLS, select the System tab.
b. From the N
avigation Tree, select Nodes,thenaspecific node, then Fibre Channel.
The statu
s pane displays information about the FC ports including the world wide port names
(WWPNs) (Figure 14).
Figure 14 Fibre Channel details window
c. Write down the WWPN for each storage port on the node. There is no need to write down the
WWPNs for the host ports.
d. Repeat these steps for each node on the VLS300.
2. Create a host entr y for the VLS d evice using the WWPNs gathered in the previous step:
HP StorageWorks
37