Table 8 CLI management commands
Command
Usage
1
changePasswor
d
Reset the admin
istrative password, or change the
administrati
ve or user password. Command View VLS
automaticall
y restarts after changing the password(s) to
make the changes take effect. Where the options are:
-admin - Reset the administrator password ( -u and
-p are ignored) (optional)
-p -Password(nospaces)(optional)
-u - Username (administrator or user). Default is
current user. (optional)
-h - Displays command usage information (optional)
editCartridge
Change an existing cartridge parameters. Where the
options are:
-a <s> -VLSfilename of the cartridge (required)
-b <s> - Barcode label of the cartridge (required)
-c <n> - Current capacity of the cartridge in
gigabytes (optional). Only required if changing the
cartridge capacity.
-l <s> - Name of library in which the cartridge
resides (Library_0, ...) (required)
-nc <n> - Desired new capacity of the cartridge in
gigabytes (optional)
-nl <s> - N ame of the new library if moving
cartridge (Library_1, ..) (optional)
-w - Write protect? (0-read/write or 1-read only)
(optional)
-y <n> - Cartridge emulation type (2, 3, ...)
(required)
-h - Displays command usage information (optional)
restartEmulations
Restarts the VLS device emulations.
restart
CommandViewVLS
Restart
s Command View VLS.
restartSystem
Shuts down and restarts the VLS node.
shutdownSystem
Shuts down the VLS node so it can be powered off.
saveAl
lConfig
Where t
he options are:
-o <s> -
Saves the VLS virtual library configuration
and network settings to the specified external
config
uration file.
-h - Displays command usage information (optional)
restoreAllConfig
Where the options are:
-in <s> - Restores the VLS virtual library configuration
and network settings from the specified external
configuration file.
-h - Displays command usage information (optional)
1
<s>=string;<n>=number;<f>=filena me
Monitoring commands
Use t
he CLI commands in to:
• View the VLS health status
HP StorageWorks
115
To Next Page
Loading...
