HP StorageWorks 300 - Virtual Library System EVA Gateway - Create Virtual Library Wizard Window (2 of 12)

NOTE:
The only library emulation Veritas supports for use with Netbackup is the HP VLS emulation.
The HP VLS emulation was created specifically for use with Netbackup. It is not intended for
use with other backup applications.
7. Click Next Step.
The next wizard window opens and displays the default values in the Maximum Slots, Maximum
Ports, and Maximum Drives boxes based on the physical tape librar y emulation selected ( Figure 38).
Figure 38 Crea te Virtual Library Wizard window (2 of 12)
8. Enter the maximum number of cartridge slots that may be added to the library in the Maximum
Slots box.
The default values in Maximum Slots box is based on the physical tape library you selected.
CAUTION:
Changing the defaults can have unpredictable results if your backup application expects a
certain number of slots in a specificlibrarytype.
9. Enter the maximum number of input/export ports on which the library may be configured to be
visible in the Maximum Ports box.
10. Enter the maximum number of tape drives the library may contain in the Maximum Drives box.
NOTE:
The maximum values entered cannot be changed later. So, consider your potential future
requirements when entering values.
Not all of the tape driv es and cartridges must be created at this time. You may add tape
drives later.
11 . Click Next Step.
A window o pens indicating that by default all libraries connected to the VLS have access to all
hosts (Figure 39).
HP StorageWorks
73