Figure 28 Restart Command View VLS window
4. Click Re start to confi rm.
Closing a Command View VLS session
To close a C
ommand View VLS session, click Logout in the status banner or simply close the web browser.
Secure shell and ser ial user interfaces
The secure shell user interface p rovides remote configuration and management of your VLS over a
L AN using the VLS command-line interface (CLI) com m and set. The serial user interface provides local
configuration and management of your VLS through the serial connector on the rear of the VLS node 0
using the same VLS CLI command set.
A secure shell or serial session pr ovides the following:
• Setting the VLS network settings
• Configuration and management of VLS virtual devices (libraries a n d tape drives) and cartridges
• Changing of the default FC host port settings
• Viewing and deleting VLS notification alerts
• Configuring VLS mail and SNMP notification alert settings
• Editing VLS account passwords
• Enabling and disabling storage capacity oversubscription
• Viewing VLS hardware status
• Saving and restoring VLS network settings and virtual library configurations
• Restarting VLS device emulations and Command View VLS
• Rebooting and powering off the VLS
The serial user interface also provides:
• Emergency login access that allows you to change the administrator password if it is forgotten.
Open
ing a secure shell session
NOTE:
Before you can open a secure shell session, you must set the VLS network settings. See Setting the
network settings.
58
User interfaces
To Next Page
Loading...
