Switch 2524 replacement
To replace the 100 Mb Ethernet switch 2524:
1. Power off th
esystem. SeePowering off the system.
2. Make a note o
f a ll cable connections to the switch then disconnect the cables.
3. From the front of the node, loosen the captive thumbscrews until the thumbscrews are free of the rack.
4. Pull the switch out from the rack until it stops.
5. Squeeze th
e release brackets, then pull the node free from the rails.
6. Install the new switch into the rack. See Install the 100 Mb Ethernet switch 2524 into a rack.
7. Reconnect all cables to the new switch exactly as they were connected to the failed switch.
8. Power on t
he system. See Powering on the VLS300 system.
Switch 2824 replacement
To replace the 1 Gb Ethernet switch 2824:
1. Power off the system. See Powering off the system.
2. Make a note of all cable connections to the switch then disconnect the cables.
3. From the front of the node, loosen the captive thumbscrews until the thumbscrews are free of the rack.
4. Pull the switch out from the rack until it stops.
5. Squeeze the release brackets, then pull the nod e free from the rails.
6. Install the new switch into the rack. See Install the 1 Gb Ethernet switch 2824 into a rack.
7. Reconnect all cables to the new switch exactly as they were connected to the failed switch.
8. Power on the system. See Powering on the VLS300 system.
USB LAN adapter
To replace the USB LAN adapter:
1. Powe
r off the node and switch to which the USB LAN adapter is attached. See Powering off the system
2. Dis
connect the USB LA N adapter by unplugging the USB cable from the node and u nplugging
the
Ethernet cable from the adapter.
3. Connect the new USB LAN adapter by connecting the USB cable to the node por t from which the
previous cable was removed, and plugging the Ethernet cable into the USB LAN adapter.
4. Po
wer on the system. See Powering on the VLS300 system.
HP StorageWorks
141
To Next Page
Loading...
