HP StorageWorks 300 - Virtual Library System EVA Gateway - Saving Configuration Settings; Software Update Window

Figure 61 So
ftware Update window
5. Click Browse.
6. Select the firmware.zip file.
7. Click Next Step.
The window displays:
Uploading the file
8. Click Next Step to confirm that you want to load the new software.
The Software Update Finished window opens and displays a message indicating that the upgrade
was successful.
9. Click Finish to return to the S ystem tab window.
Saving configuration settings
NOTE:
The VLS software ensures a persistent VLS serial number and FC port WWPNs, so that in the event of
any hardware failure and replacement (such as the system board or FC host bus adapter card), the VLS
still appears exactly the same to the external SAN. It does this by generating a V LS serial number and
FC port WWPNs at first boot, which are based on the system board’s MAC add ress. The VLS serial
number and FC port WWPNs are saved on the VLS hard drives and with the virtual library configuration
settings in the configuration file.
HP highly recommends that you save your virtual library configuration and the VLS network settings to an
external configuration file, so they can be restored in the event of a disaster.
To save your virtual library configuration and the VLS network settings to an external configuration file:
1. Open a Command View VLS session and log in as the administrator. See Opening a Command
View VLS session from Command View TL.
2. Select Chassis in the navigation tree.
3. Click Save Config under Maintenance Tasks.
The Save Configuration window opens (Figure 62).
96
Management