Table 50 Error codes (part code 6005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WThe number of paths is less than the
minimum number specified on the RCU
Option dialog box. Check the number
of paths, establish the minimum number
of paths, and retry the operation.
The specified number of Paths is less than
the Minimum number of Paths on RCU
Option screen.
87036005
WCheck the paths status and reestablish
the paths.
The specified number of paths is less
than the minimum number of paths on
the RCU option screen due to a
communication error between the MCU
and the RCU.
87046005
WEither a communication error occurred
between the MCU and the RCU, or the
CHA has become blocked. Please
contact HP Technical Support.
The path could not be deleted due to a
communication error between MCU and
RCU.
87056005
WSpecify a correct value.Parameter specified by Remote Copy
operation is invalid.
87066005
WCheck the pair status for Continuous
Access Synchronous. If the requested
R-VOL is in a permissible status, please
retry the operation.
The pair status of the R-VOL is not valid.87086005
EAll channel adapters are not active for
Continuous Access Synchronous. Please
contact HP Technical Support.
Remote Copy operation was rejected.87096005
WThe pair status does not permit this
operation. Verify the pair status, and if
the operation is permitted retry.
The pair status of the specified volume
is not valid.
87106005
WCheck if the specified Port, GID, LUN,
CU, or LDEV number exists in the storage
system.
The Port, GID, LUN, CU, or LDEV number
of the specified volume is incorrect.
87116005
WIf this was a path operation retry after
the problem has been fixed.
If this was a pair operation, retry after
the paths have been recovered. Two
ways to recover paths are:
(a) Execute ESTPATH from the host
console, or
(b) First delete the path(s) from the SVP,
then re-add them.
The operation was rejected due to a
'FREEZE' state.
87126005
WThe port type could not be changed
because the port group was set in the
specified package. Delete the group
setting, then change the port type.
The port group already exists on the
specified port.
87136005
EPlease contact HP Technical Support.An internal error occurred.87146005
WThe specified number of paths is not
within the acceptable path range of 0 to
4. Verify the number of paths and retry
the operation.
Invalid number of paths.87156005
WThe specified logical address must be
either 00 or 01. Check the logical
address and retry the operation.
Invalid Destination Link Address.87176005
136 Message (part code group 6nnn)
To Next Page
Loading...
