Table 50 Error codes (part code 6005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck all existing logical path
addresses, and specify another link
address or port.
The specified logical path already exists.87186005
WCheck the serial number, SSID, link
address and controller ID of the RCU,
and set the correct value. Then retry the
operation. If the same error occurs,
please contact HP Technical Support.
Invalid RCU serial number, SSID, Link
Address or Controller ID.
87196005
WA maximum of four RCUs are permitted,
and that many already exist.
Too many RCUs. (Four RCUs are the
maximum.)
87206005
WCheck the path connections between the
MCU and the RCU, then retry the
operation.
Path not completely established.87216005
WCheck the path connections between the
MCU and the RCU, then retry the
operation.
Failure during path creation.87226005
WAdd another path, or delete all pairs on
the RCU. Then retry the operation.
The Edit Path operation was rejected
because the specified path is the last
path of some Remote Copy pairs.
87236005
WThe specified number of paths is less
than the minimum number of paths
specified on the RCU Option window.
Specified number of paths is less than
the minimum specified on RCU Option
screen.
87246005
WThe version of the microcode on the
XP512/XP48 Disk Array does not
support the specified function or
operation. Please contact HP Technical
Support.
Current microcode version does not
support the specified operation.
87256005
WAdd the normal path(s), then set the
minimum number of paths.
The number of minimum paths exceeds
the number of normal paths.
87276005
WPlease take either of the following
actions:
Add normal paths, then delete the paths.
Decrease the number of minimum paths,
then delete the paths.
The number of minimum paths exceeds
the number of normal paths.
87286005
EPlease contact HP Technical Support.An internal error occurred.87296005
WIf you are adding RCUs, specify the
same logical address.
If you are editing paths, specify the same
logical address as the existing paths.
(See the Edit Path dialog box.)
Invalid Logical Addresses are specified.87306005
WThe logical addresses of all existing
paths are not the same. Delete the RCU,
then re-add it, using the same logical
address as other existing paths.
The existing logical addresses are not
equal.
87316005
WThe maximum number of SSIDs (four) has
been entered. Verify that the SSIDs are
valid, delete one or more, then retry the
operation.
Too many SSIDs(Only Four SSIDs are
allowed).
87326005
WInstall the program product key in the
MCU.
The Fibre-Remote Copy function is not
installed in the specified MCU.
87336005
Part code 6005 137
To Next Page
Loading...
