Table 52 Error codes (part code 6010) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EPlease contact HP Technical Support.An error occurred in the client logic.73026010
EPlease contact HP Technical Support.An error occurred in the client logic.73036010
EIf this problem persists, please contact
HP Technical Support.
An error occurred during processing. If
this problem persists, please contact HP
Technical Support.
74406010
WClick [Refresh], and retry.The system cannot apply the new
configuration. Do you want to refresh?
81016010
WClick [Yes] to recover from the error
condition. If not, click [No].
If the recovery fails despite retrying,
suspend the corresponding pair
temporarily, and execute Resume Pair
(Pairresync) operation.
An error occurred when copying started.
Do you want to recover from the error
condition?
89286010
iFollow the instructions in the message.Exchange the channel cable connections
after confirmation of the port type.
90066010
iConfirm that the R-VOLs to specify are
varied off-line.
Please confirm that the R-VOLs to specify
are varied off-line.
90076010
iClick [OK].SIMs of Remote Copy are cleared.90086010
iClick [OK].The export is complete.90096010
iClick [Yes] to continue processing. After
processing is complete, reset the port
that is not in operation.
The Port Setting process has not
completed. Do you want to continue for
other ports?
90216010
iCheck the contents of the main and
remote volumes. If the contents match,
click [OK]. If not, click [Cancel].
WARNING: Initial copy mode 'None'
is selected for some volume pairs. Are
you sure that the M-VOL and the R-VOL
of these pairs are already synchronized?
90226010
iFollow the instructions in the message.Are you sure you want to exchange the
specified ports? Please confirm the
associated channel paths are off-line.
90246010
iTo continue the operation, click [OK].
Otherwise, click [Cancel].
Are you sure you want to switch the
ports? If the remote copy paths exist on
the ports, delete them beforehand.
90256010
iTo continue the operation, click [OK].
Otherwise, click [Cancel].
Are you sure you want to switch the
ports? If any remote copy paths exist on
the ports, delete them beforehand. Also,
to avoid the switching operation from
being reported as a failure, confirm first
that a message prompting you to change
the channel cable connections is
displayed, and then perform the
necessary changes.
90266010
WTo delete the specified RCU, click [OK].
Otherwise, click [Cancel].
Are you sure you want to delete the
specified RCUs?
90706010
WTo delete the specified path, click [OK].
Otherwise, click [Cancel].
Are you sure you want to delete the
paths of a specified RCU?
90716010
WTo delete the specified pair, click [OK].
Otherwise, click [Cancel].
Are you sure you want to delete the
specified volume pairs?
90726010
Part code 6010 159
To Next Page
Loading...
Need help?
General