Table 53 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
ECheck the SSB log, then contact HP
Technical Support.
An internal error occurred.88936505
WStop the jobs from the host and retry the
operation.
Jobs exist on the port.88946505
WStop the jobs from the host and retry the
operation.
Jobs exist on the port on the remote
subsystem.
88956505
WRefresh the window, and retry. If nothing
changes, please contact HP Technical
Support.
Parameter error has occurred.88966505
WDelete the LUs defined on the port, and
retry the operation.
LUs exist on the port.88976505
WRetry the operation.Pending data exists on the port.88986505
ECheck the SSB log, then contact HP
Technical Support.
An internal error occurred.88996505
EPlease contact HP Technical Support.An error occurred during the port
change.
89006505
EPlease contact HP Technical Support.An error occurred during the port
change.
89016505
EPlease contact HP Technical Support.An error occurred during the port
change.
89026505
EPlease contact HP Technical Support.Unknown Error Code.89036505
WCheck the status of the port, and retry
the operation.
Remote Web Console attempted to
change the port type. However, this
attempt was rejected because the same
operation was in progress from a host.
89156505
WCheck whether the primary storage
system supports remote copy via serial
interface. Install the microcode that
supports remote copy via serial interface,
or execute remote copy via fibre
interface.
The primary storage system does not
support remote copy function via the
serial interface.
89226505
wDelete the logical paths on the specified
port, and retry the operation.
Logical paths are defined to the port on
the remote subsystem.
89246505
WCheck the port type of the specified port,
and retry the operation.
Invalid port type.89296505
WDelete the logical paths on the specified
port, and retry the operation.
Logical paths are defined to the port on
the remote subsystem.
89306505
WDelete the logical paths on the specified
port, and retry the operation.
Logical paths are defined to the port on
the remote subsystem.
89316505
WCheck whether the specified LDKC
number is defined in the configuration
of the primary storage system.
Failed to create the logical path, because
the configuration definition of the
specified LDKC number did not exist in
the primary storage system.
89326505
WCheck the configuration of the specified
secondary data volume.
The Add Pair (Paircreate) operation
failed because the specified secondary
data volume was a NAS system volume.
89346505
172 Message (part code group 6nnn)
To Next Page
Loading...
