Table 55 Error codes (part code 6510) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WTo execute the processing and close the
graph, click [OK], Otherwise, click
[Cancel].
The graph will be closed if you execute
the processing. Do you want to execute
the processing?
91206510
WTo execute this operation, click [OK],
Otherwise, click [Cancel].
Data has been changed and the graph
has been displayed. If you continue this
operation, all the data and the graph
will become invalid. Are you sure you
want to continue this operation?
91216510
iTo export the pair status, click [OK].
Otherwise, click [Cancel].
Are you sure you want to export pair
status?
91226510
WTo close the graphs, click [OK].
Otherwise, click [Cancel].
Are you sure you want to close all active
graphs?
91276510
WClick [OK], then specify the correct
volume.
The specified volume was not found.91286510
iClick [OK].The history file has been updated. Select
the OK button to display the history logs
from the beginning.
91556510
WCheck the device emulation or the
definition of the SCSI path.
There are no valid volumes.93036510
WSet the port to Initiator before registering
the storage system.
There are no initiator ports.93056510
WObtain a license for Continuous Access
Journal, then install it.
The Continuous Access Journal function
is not installed in this controller. You
cannot create pairs.
93066510
WSince there are duplicated paths in the
added paths, the duplicated paths will
be eliminated. Click [OK] to continue.
You set the same path more than once.
The duplicate paths are excluded.
93086510
WSince all the added paths are redundant,
the paths cannot be added. Click [OK]
and continue.
All paths which you set have already
been registered. This operation will
terminate because there is no path which
can be added.
93096510
iClick [Refresh] to update the history file.
If this problem persists, please contact
HP Technical Support.
The monitoring time is over, but the
history file is not fully updated yet.
93276510
iClick [OK], then continue the operation.This operation is not applied yet.93326510
WCheck the number of data volumes in the
journal. Then delete unused data volume
pairs, or register them in another journal.
Too many data volumes in the journal.550366510
WCheck the number of mirrors in the
journal. Then delete unused mirrors, or
register them in another journal.
Too many mirrors in the journal.550376510
WCheck the number of mirrors in the
journal group, then delete unused
mirrors.
Too many mirrors in the subsystem.550386510
WCheck the range setting. If you specify
"Mirror," select only one data volume
pair in the mirror.
You are specifying "Mirror" for the range
and trying to manipulate the same
mirror. Select only one data volume pair
in the mirror when you specify "Mirror"
for the range.
550396510
206 Message (part code group 6nnn)
To Next Page
Loading...
Need help?
General