Table 22 Error codes (part code 00622) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the setting(s).A radio button is not selected.10523400622
WSelect one or more table rows.The operation cannot be done because
no row is selected.
10523500622
WSet a target to be operate on the selected
table, then execute the operation.
The operation cannot be executed
because no target item is selected.
10523600622
WCreate an external path group.External path group creation has not
finished yet.
10523700622
WCheck the setting(s).Failed to allocate a Parity Group ID.10523800622
WCheck the number of selected alternate
paths.
The number of alternate paths that can
be set to an external volume exceeds the
maximum.
10523900622
WCheck the number of registered external
path groups.
Failed to allocate an External Path Group
ID.
10524000622
WSee the manual of the external device
and check the setting of the external
volume.
An external volume that can be added
was not found by the result of
VolumeDiscovery.
10524100622
WResolve the cause of the error, or only
select an available external volume.
An external volume is selected, where
Volume Discovery executed ends with
an error.
10524200622
WCheck the setting(s).The emulation type that cannot coexist
is set.
10524300622
WCheck the contents of the path
configuration.
The specified external volume cannot be
set because the path configuration is
different.
10524400622
WCheck the setting(s).Failed to allocate a LDEV ID.10524500622
WCheck the setting(s).Failed to allocate a SSID.10524600622
WResolve the cause of the error, or only
select an available external volume.
The external volume is not supported.10525100622
WCheck the setting(s).Only one LDEV can be set because the
attribute of the specified external volume
is Remote Command Device.
10525500622
WCheck the setting(s).Only one LDEV can be set because the
specified external volume is in the data
transfer mode.
10525600622
WCheck the setting(s).LDEV Name cannot be set because the
value is out of range.
10525700622
WSelect one or more normal path, or
restore the path.
The path cannot be changed because
there will be no normal path for the
external volume.
10525800622
WEdit LDEVs, or recreate external volumes
if you want to register the LDEV Name.
LDEV Name can not be registered
because there is a volume that failed to
be created as an external volume.
10526200622
WReduce the number of external volumes
to be mapped, then retry the operation.
Or, check the initial-number of LDEV ID
or the interval setting.
Insufficient logical volumes to map the
external volumes.
10526500622
Part code 00622 49
To Next Page
Loading...
Need help?
General