Table 25 Error codes (part code 1005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
20091005
WRecovery processing may take about 1
minute. Wait for a while.
The LDEV is being used by the host, or
an error occurred in the SVP procedure.
20101005
WIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
20131005
WIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred while connecting to
the storage system.
20151005
WIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred while connecting to
the storage system.
20321005
WUnmount the host and cancel reservation
of the device. If the host is an AIX host,
unmount the host, and execute the
varyoffvg command.
Processing is disabled because the host
is mounted or the device is reserved.
20821005
WCheck the DKC status and the current
status of the configuration setting. If
necessary, re-execute the setting
operation.
The subsystem status is invalid.20831005
WCheck the DKC status and the current
status of the configuration setting. If
necessary, re-execute the setting
operation.
The subsystem status is invalid.20841005
WCheck the settings, then retry the
operation.
The host specified by the WWN is
performing I/O operations.
20971005
EWhen the same problem persists, please
contact HP Technical Support.
The operation cannot be performed,
because the SVP microcode version does
not match the DKCMAIN (subsystem)
microcode version.
20981005
WWait a while, then retry the operation.
If the same problem persists. Please
contact HP Technical Support.
The operation cannot be performed,
because an inoperative Processor exists.
20991005
WClick [Refresh All] on the [File] menu,
then refresh the configuration. If the same
problem persists despite retrying, please
contact HP Technical Support.
An error occurred while connecting to
the storage system. The configuration
may be inconsistent.
21001005
WCorrect the settings, then retry.The volume cannot be configured as a
command device because the volume
does not have Read/Write attribute.
25011005
WRelease the reserved attribute of the
target volume by using Data Retention.
No settings can be made because of a
volume reserved for RAID Manager.
25041005
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
30021005
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
30031005
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
30061005
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
30071005
58 Message (part code group 1nnn)
To Next Page
Loading...
Need help?
General