Table 25 Error codes (part code 1005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WTo add the host group, change the
attribute of the specified port to Target
or RCU Target.
You could not add the host group to the
initiator or external port.
13561005
WThe specified port is for Fibre Continuous
Access Synchronous. Delete a logical
path, then retry the operation.
S-VOLs remain on the Fibre-RCU port.
This operation may cause a fatal
damage to the S-VOLs. Please stop this
operation. If you want to continue this
operation, please remove the S-VOLs
from the RCU port first.
13571005
WReduce the number of user LU settings,
then retry the operation.
No more user LUs can be set, because
the number of user LU settings has
reached the maximum.
13611005
WCorrect the settings, then retry the
operation.
You cannot add paths to journal
volumes.
13631005
WCheck the port type, then retry the
operation.
The port type is incorrect.13641005
WCheck the settings, then retry.The host mode "4C" is used for a host
group connecting to volumes that cannot
be used for External Storage.
13671005
WCheck the settings, then retry.The host mode "4C" can only be used
with External Storage volumes.
13681005
WInstall the necessary license key.This functionality is not available. Open
System Array Management is required.
16001005
WInstall the necessary license key.This functionality is not available. Open
System Array Management is required.
16011005
WSelect another volume.The specified volume cannot be assigned
as an LUSE volume or a command
device, and the path of the volume
cannot be set because it is being used
as a Pool volume.
19041005
WSelect another volume.The specified volume cannot be set as a
command device because it is being
used as a V-VOL for Snapshot.
19061005
WCorrect the settings, then retry the
operation.
The specified volume is a remote
command device, and therefore the
command device setting or the command
device security setting cannot be set or
released.
19121005
WDelete the external volume that is
mapped to the external port to be
operated, then retry the operation.
An external volume is mapped to the
external port to be operated.
19181005
WCheck the setting.The path cannot be set to the specified
volume, because the volume is being
used as a quorum disk.
19261005
WCheck the setting.The specified volume cannot be set as a
command device, because it is being
used as a quorum disk.
19271005
WIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
20051005
Part code 1005 57
To Next Page
Loading...
Need help?
General