Table 25 Error codes (part code 1005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the setting(s), then retry the
operation.
When setting the port information (Fibre
Address/Fibre Topology/Channel
Speed), multiple change instructions are
set to the same port.
11351005
WThe configuration information has been
changed already. Check the settings,
and request the configuration information
setting again.
The same setting is specified at LUNM
operation.
11381005
WRelease the Port Group setting.Because the Port Group setting is done,
it is impossible to change.
11401005
WCorrect settings, then retry.The volume cannot be configured as a
command device because the volume
does not have Read/Write attribute.
11701005
WCorrect the settings, then retry.The specified host ID is already
registered.
11741005
WCorrect the settings, then retry.The specified host is already registered.11771005
WCorrect the settings, then retry.An incorrect host name was specified.11781005
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
11801005
WCorrect the specification, then retry the
operation.
The specified path cannot be added,
because the volume is used by a Remote
Copy pair.
11811005
WCorrect the settings, then retry.No information can be changed about
this external port because the port has
an external volume.
11941005
WCheck the setting.The path cannot be set to the specified
volume because the volume is not an
open-systems volume.
11991005
WTo add a path, change the attribute of
the specified port to Target or RCU
Target.
You could not add the path to the
initiator or external port.
13501005
WSince the port you are trying to set is for
Remote Copy, you must delete the logical
path, then retry the port setting.
Logical paths remain on the Fibre-MCU
port. This operation may cause a fatal
damage to the logical paths. Please stop
this operation. If you want to continue
this operation, please remove the logical
paths from the MCU port first.
13521005
WSince the port you are trying to set is for
Remote Copy, you must delete the S-VOL
logical path that is set to RCU Target,
then retry the port setting.
S-VOLs remain on the Fibre-RCU port.
This operation may cause a fatal
damage to S-VOLs. Please stop this
operation. If you want to continue this
operation, please remove the S-VOLs
from the RCU port first.
13531005
WTo register the WWN, change the
attribute of the specified port to Target
or RCU Target.
You could not register the WWN to the
initiator or external port.
13541005
WTo change the host mode, change the
attribute of the specified port to Target
or RCU Target.
You could not change the host mode of
the host group that you connected to the
initiator or external port.
13551005
56 Message (part code group 1nnn)
To Next Page
Loading...
Need help?
General