System Diagnostics and
Troubleshooting
121
207—ECC Corrected Single Bit
Errors in Memory Socket(s) y,y
Single Bit ECC error. 1. Verify proper memory module type.
2. Try another memory socket.
3. Replace memory module if problem persists.
212—Failed Processor Processor has failed to initialize. 1. Reseat the processor in its socket.
2. If the processor does not respond, replace it.
213—Incompatible memory
Module in memory Socket(s)
X,X, X
A memory module in memory socket
identified in the error message is missing
critical SPD information, or is
incompatible with the chipset.
1. Verify proper memory module type.
2. Try another memory socket.
3. Replace memory with a module conforming to the
SPD standard.
214—DIMM Configuration
Warning
DIMMs not installed correctly (not
paired correctly).
Refer to section 4.19 “Memory” for the correct memory
configurations and reseat the DIMMs accordingly.
215—Memory Mismatch
Warning
There are one or more mismatched pairs
of DIMMs between channel A and
channel B. Some memory has been
disabled. Install matching pairs.
Refer to section 4.19 “Memory” for the correct memory
configurations and reseat the DIMMs accordingly.
301—Keyboard Error Keyboard failure. 1. Reconnect keyboard with workstation turned off.
2. Check connector for bent or missing pins.
3. Be sure that none of the keys are pressed.
4. Replace keyboard.
303—Keyboard Controller Error I/O board keyboard controller. 1. Reconnect keyboard with workstation turned off.
2. Replace the system board.
304—Keyboard or System Unit
Error
Keyboard failure. 1. Reconnect the keyboard with workstation turned off.
2. Be sure that none of the keys are pressed.
3. Replace keyboard.
4. Replace system board.
402—Parallel Port 2 Address
Assignment Conflict
IRQ address conflicts with another
device.
Reset the IRQ.
501—Display Adapter Failure Graphics display controller. 1. Reseat the graphics card (if applicable).
2. If using PCI Express card with auxiliary power
cable, be sure it is attached.
3. Clear CMOS.
4. Verify that the monitor is attached and turned on.
5. Replace the graphics controller.
510—Splash Screen image
corrupted
Splash Screen image has errors. Install latest version of ROMPaq to restore image.
511—CPU0 or CPU1 Fan not
detected
Fan is not connected or might have
malfunctioned.
1. Reseat fan cable.
2. Reseat the fan.
3. Replace the fan.
512—Chassis, rear chassis, or
front chassis fan not detected
Fan is not connected, might have
malfunctioned.
1.
Reseat chassis, rear chassis, or front chassis fan
cable.
2. Reseat chassis, rear chassis, or front chassis fan.
3. Replace chassis, rear chassis, or front chassis fan.
601—Diskette Controller Error Diskette controller circuitry or diskette
drive circuitry incorrect.
1. Run Computer Setup (F10 Setup).
2. Check and replace cables.
3. Clear CMOS.
4. Replace diskette drive.
5. Replace the system board.
605—Diskette Drive Type Error Mismatch in drive type. 1. Run Computer Setup (F10 Setup).
2. Disconnect any other diskette controller devices
(tape drives).
3. Clear CMOS.
Table 5-18 POST Error Messages (continued)
Screen Message Probable Cause Recommended Action
To Next Page
Loading...
