HPE FlexNetwork MSR Series - Wlan Client-Rate-Limit

104
Use svp map-ac disable to disable SVP mapping.
Use undo svp map-ac to restore the default.
Syntax
svp map-ac { ac-vi | ac-vo }
svp map-ac disable
undo svp map-ac
Default
SVP mapping is disabled.
Views
Radio interface view
Predefined user roles
network-admin
Parameters
ac-vi: Specifies the AC-VI (video traffic) queue.
ac-vo: Specifies the AC-VO (voice traffic) queue.
Usage guidelines
SVP mapping takes effect only on non-WMM clients.
Examples
# Map SVP packets to the AC-VO queue.
<Sysname> system-view
[Sysname] interface wlan-radio 0/1
[Sysname-WLAN-Radio0/1] svp map-ac ac-vo
wlan client-rate-limit
Use wlan client-rate-limit to configure client-type-based client rate limiting.
Use undo wlan client-rate-limit to remove the configuration.
Syntax
wlan client-rate-limit { dot11a | dot11ac | dot11an | dot11b | dot11g | dot11gn } { inbound |
outbound } cir cir [ cbs cbs ]
undo wlan client-rate-limit [ { dot11a | dot11ac | dot11an | dot11b | dot11g | dot11gn } [ inbound
| outbound ] ]
Default
Client-type-based client rate is not limited.
Views
System view
Predefined user roles
network-admin
Parameters
dot11a: Specifies 802.11a clients.
dot11ac: Specifies 802.11ac clients.