30
Default
The match mode is none for client radio resource measurement capabilities.
Views
Radio interface view
Predefined user roles
network-admin
Parameters
all: Specifies the all mode. A client is allowed to associate with the AP only when all its radio resource
measurement capabilities match the AP's radio resource measurement capabilities.
none: Specifies the none mode. The AP does not check client radio resource measurement
capabilities.
partial: Specifies the partial mode. A client is allowed to associate with the AP as long as one of its
radio resource measurement capabilities matches any of the AP's radio resource measurement
capabilities.
Usage guidelines
The configuration takes effect only when radio resource measurement is enabled.
Examples
# Set the match mode to partial for client radio resource measurement capabilities.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] rm-capability mode partial
Related commands
resource-measure
spectrum-management
Use spectrum-management enable to enable spectrum management.
Use spectrum-management disable to disable spectrum management.
Use undo spectrum-management to restore the default.
Syntax
spectrum-management { disable | enable }
undo spectrum-management
Default
Spectrum management is disabled.
Views
Radio interface view
Predefined user roles
network-admin
Usage guidelines
When spectrum management is enabled on the AP, the AP sets the Spectrum Mgmt field to 1 in
beacons, probe responses, association responses, or reassociation responses. It notifies the clients
that the AP supports 802.11h and they can send 802.11h measurement requests.
To Next Page
Loading...
Need help?
General
