97
Usage guidelines
For this command to take effect, make sure service-template-based client rate limiting is enabled.
You can repeat this command multiple times to limit the rates of both the incoming and outgoing
traffic.
Examples
# Configure rate limiting for service template 1: set the CIR to 567 Kbps for each client's incoming
traffic.
<Sysname> system-view
[Sysname] wlan service-template 1
[Sysname-wlan-st-1] client-rate-limit enable
[Sysname-wlan-st-1] client-rate-limit inbound mode static cir 567
Related commands
client-rate-limit enable
client-rate-limit enable
Use client-rate-limit enable to enable service-template-based client rate limiting.
Use undo client-rate-limit enable to restore the default.
Syntax
client-rate-limit enable
undo client-rate-limit enable
Default
Service-template-based client rate limiting is disabled.
Views
Service template view
Predefined user roles
network-admin
Usage guidelines
This command limits the traffic rate of the WLAN clients associated with a service template. To set
the rate limit direction and rate limit rate, use the client-rate-limit command.
You can configure different rate limit methods and rate limit modes for client rate limiting, and all
settings take effect. The minimum value for the rate limit among these settings will apply to each
client.
Examples
# Enable client rate limiting for service template 1.
<Sysname> system-view
[Sysname] wlan service-template 1
[Sysname-wlan-st-1] client-rate-limit enable
Related commands
client-rate-limit
To Next Page
Loading...
Need help?
General
