6
Use client dot11n-only disable to disable the client dot11n-only feature.
Use undo client dot11n-only to restore the default.
Syntax
client dot11n-only { disable | enable }
undo client dot11n-only
Default
The client dot11n-only feature is disabled.
Views
Radio interface view
Predefined user roles
network-admin
Usage guidelines
This command is applicable only to 802.11n radios. Changing the radio mode to 802.11a, 802.11b, or
802.11g invalidates the command.
After you configure this command on a radio, the radio accepts only the 802.11n clients, and all
802.11a/b/g clients that are associated with the radio are logged off.
Examples
# Enable the client dot11n-only feature.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] client dot11n-only enable
client max-count
Use client max-count to set the maximum number of clients that can associate with the AP.
Use undo client max-count to restore the default.
Syntax
client max-count max-number
undo client max-count
Default
No limit is set for the number of clients that can associate with the AP.
Views
Radio interface view
Predefined user roles
network-admin
Parameters
max-number: Specifies the maximum number of clients that can associate with the AP, in the range
of 1 to 124.
Usage guidelines
When the maximum number of clients is reached on an AP, the AP stops accepting new clients.
To Next Page
Loading...
Need help?
General
