24
WLAN radio resource measurement
commands
WLAN is supported only on the MSR954(JH297A/JH298A/JH299A).
The term "AP" in this document refers to MSR routers that support WLAN.
display wlan measure-report
Use display wlan measure-report to display measurement reports for clients.
Syntax
display wlan measure-report interface interface-type interface-number [ client mac-address
mac-address ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies a radio interface by its type and number.
client mac-address mac-address: Specifies a client by its MAC address. If you do not specify a
client, this command displays measurement reports for all clients.
Examples
# Display measurement reports for clients associated with the specified radio interface.
<Sysname> display wlan measure-report interface wlan-radio 0/0
Total number of clients: 1
Client MAC address : 0aef-e760-3587
Link measurement:
Link margin : 2 dBm
RCPI : -85 dBm
RSNI : 53 dBm
Noise histogram:
Antenna ID : 3
ANPI : -56 dBm
IPI0 to IPI10 density : 5 12 16 13 8 5 5 15 17 1 3
Spectrum measurement:
Transmit power : 20 dBm
BSS : Detected
OFDM preamble : Detected
Radar : Detected
Unidentified signal : Undetected
CCA busy fraction : 60
RPI0 to RPI7 density : 3 7 11 19 15 23 15 7
To Next Page
Loading...
