HPE FlexNetwork MSR Series - Radio Management Commands; A-Mpdu; A-Msdu

1
Radio management commands
WLAN is supported only on the MSR954(JH297A/JH298A/JH299A).
The term "AP" in this document refers to MSR routers that support WLAN.
a-mpdu
Use a-mpdu enable to enable the A-MPDU aggregation method.
Use a-mpdu disable to disable the A-MPDU aggregation method.
Use undo a-mpdu to restore the default.
Syntax
a-mpdu { disable | enable }
undo a-mpdu
Default
The A-MPDU aggregation method is enabled.
Views
Radio interface view
Predefined user roles
network-admin
Usage guidelines
This command is applicable only to 802.11n radios. Changing the radio mode to 802.11a, 802.11b, or
802.11g invalidates the command.
Examples
# Disable the A-MPDU aggregation method.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] type dot11an
[Sysname-WLAN-Radio0/0] a-mpdu disable
a-msdu
Use a-msdu enable to enable the A-MSDU aggregation method.
Use a-msdu disable to disable the A-MSDU aggregation method.
Use undo a-msdu to restore the default.
Syntax
a-msdu { disable | enable }
undo a-msdu
Default
The A-MSDU aggregation method is enabled.
Views
Radio interface view