32
Band navigation commands
WLAN is supported only on the MSR954(JH297A/JH298A/JH299A).
The term "AP" in this document refers to MSR routers that support WLAN.
wlan band-navigation aging-time
Use wlan band-navigation aging-time to set the client information aging time.
Use undo wlan band-navigation aging-time to restore the default.
Syntax
wlan band-navigation aging-time aging-time
undo wlan band-navigation aging-time
Default
The client information aging time is 180 seconds.
Views
System view
Predefined user roles
network-admin
Parameters
aging-time: Specifies the client information aging time in the range of 10 to 600 seconds.
Usage guidelines
When an AP receives an association request from a client, the AP records the client's information
and starts the client information aging timer. If the AP receives a probe request or association
request from the client before the aging timer expires, the AP refreshes the client information and
resets the client information aging timer. If the AP does not receive any probe requests or association
requests from the client before the aging timer expires, the AP deletes the client's information.
Configure an appropriate client information aging time to ensure both client association and system
resource efficiency.
Examples
# Set the client information aging time to 50 seconds.
<Sysname> system-view
[Sysname] wlan band-navigation aging-time 50
wlan band-navigation balance access-denial
Use wlan band-navigation balance access-denial to set the maximum number of denials for 5
GHz association requests.
Use undo wlan band-navigation balance access-denial to restore the default.
Syntax
wlan band-navigation balance access-denial access-denial
undo wlan band-navigation balance access-denial
To Next Page
Loading...
Need help?
General
