89
Usage guidelines
This command is configurable when the service template is disabled, and it takes effect after the
service template is enabled.
When you configure this command, specify the extended keyword for Hewlett Packard Enterprise
iNode clients and the standard keyword for other clients.
This command is required only when an IMC server is used as the RADIUS server.
Examples
# Set the 802.1X EAP protocol mode to extended for service template 1.
<Sysname> system-view
[Sysname] wlan service-template 1
[Sysname-wlan-st-1] dot1x eap extended
dot1x handshake enable
Use dot1x handshake enable to enable the 802.1X online user handshake feature.
Use undo dot1x handshake enable to disable the 802.1X online user handshake feature.
Syntax
dot1x handshake enable
undo dot1x handshake enable
Default
The 802.1X online user handshake feature is disabled.
Views
Service template view
Predefined user roles
network-admin
Usage guidelines
This command is configurable when the service template is disabled, and it takes effect after the
service template is enabled.
The online user handshake feature checks the connection status of online 802.1X clients by
periodically sending handshake messages to the clients. The device sets a client to the offline state
if it does not receive responses from the client after making the maximum handshake attempts within
the handshake timer. To set the handshake timer, use the dot1x timer handshake-period
command. To set the maximum handshake attempts, use the dot1x retry command.
Examples
# Enable the online user handshake feature for 802.1X clients on service template service1.
<Sysname> system-view
[Sysname] wlan service-template service1
[Sysname-wlan-st-service1] dot1x handshake enable
Related commands
dot1x handshake secure enable
dot1x retry (Security Command Reference)
dot1x timer handshake-period (Security Command Reference)
To Next Page
Loading...
Need help?
General
