3
undo antenna type
Default
The antenna type is external.
Views
Radio interface view
Predefined user roles
network-admin
Parameters
antenna-type: Specifies an antenna type, a string of 1 to 10 characters.
Usage guidelines
Perform this task to set the antenna type for the AP. The antenna type setting for the AP must be
consistent with the type of the antenna used on the AP.
To ensure that the Effective Isotropic Radiated Power (EIRP) is within the correct range, the antenna
gain automatically changes after you set the antenna type.
Examples
# Set the antenna type to external.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] type dot11an
[Sysname-WLAN-Radio0/0] antenna type external
beacon-interval
Use beacon-interval to set the beacon interval.
Use undo beacon-interval to restore the default.
Syntax
beacon-interval interval
undo beacon-interval
Default
The beacon interval is 100 TUs.
Views
Radio interface view
Predefined user roles
network-admin
Parameters
interval: Specifies the beacon interval in the range of 32 to 8191 TUs.
Examples
# Set the beacon interval to 1000 TUs.
<Sysname> system-view
[Sysname] interface wlan-radio 0/0
[Sysname-WLAN-Radio0/0] beacon-interval 1000
To Next Page
Loading...
Need help?
General
