HPE FlexNetwork MSR Series - WLAN Access Commands; Beacon Ssid-Hide; Display Wlan Blacklist

37
WLAN access commands
The term "AP" in this document refers to MSR routers that support WLAN.
WLAN is supported only on the MSR954(JH297A/JH298A/JH299A).
beacon ssid-hide
Use beacon ssid-hide to disable advertising of the Service Set Identifier (SSID) in beacon frames.
Use undo beacon ssid-hide to restore the default.
Syntax
beacon ssid-hide
undo beacon ssid-hide
Default
The SSID is advertised in beacon frames.
Views
Service template view
Predefined user roles
network-admin
Usage guidelines
This command disables a radio from carrying SSIDs in the beacon frames and responding to probe
requests after the specified service template is bound to the radio.
Examples
# Disable advertising the SSID in beacon frames.
<Sysname> system-view
[Sysname] wlan service-template s1
[Sysname-wlan-st-s1] beacon ssid-hide
display wlan blacklist
Use display wlan blacklist to display blacklist entries.
Syntax
display wlan blacklist { dynamic | static }
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
dynamic: Specifies the dynamic blacklist.
static: Specifies the static blacklist.